TECNOCOAT

Hot spray coatings
DESMOPOL

Liquid membranes
TECNOFLOOR

Flooring systems
TECNOFOAM H2O

Polyurethane spray foam water based
TECNOFOAM HFO

Polyurethane spray foams, HFO gas based
TECNOFOAM I

Injection polyurethane foams

PRIMER

Primer range
TECNOTOP

Aliphatic top coats
SUBSTRATE PREPARATION

Products for reinforcement, joints and singular points
ADDITIVES

FILLERS

GUN CLEANER

Cleaning solvent for projection equipment

Cleaning solvent for polyurea spray equipment (Tecnocoat) and spray or injection polyurethane foam (Tecnofoam). Specified for cleaning parts exposed to contact with amines, polyols or isocyanates.



Uses

For application in the following situations:

  • Cleaning solvent for polyurea spray equipment (Tecnocoat) and spray or injection polyurethane foam (Tecnofoam).

NOTE: call our technical department about the application to other substrates or scopes of use

density 0.87 g/ml
purity  CG min. 99.0 % in weight
water content ASTM E203 max. 0.1 % in weight
acidity    ASTM  D1613 max. 0.01 % in weight
color       ASTM D5386 max. 10 Hazen
Aaspect liquid without  suspended particules
Results were performed in the laboratory at 23ºC  (73ºF) and 50% RH, under controllable conditions. These values may vary depending on the application, climatology, or substrate conditions.


TDS. Technical Data sheet(PDF)
MSDS, CERTIFICATES, APPROVALS...(link)

GENERAL SPECIFICATIONS

  • Cleaning solvent for polyurea spray equipment (Tecnocoat) and polyurethane foam (Tecnofoam).
  • Specified for cleaning parts exposed to contact with amines, polyols or isocyanates.

PACKAGING

Metal containers of two sizes: 25 l. and 5l.

HEALTH AND SAFETY

These safety recommendations for handling, are necessary for the implementation process as well as in the pre and post, on exposure to the loading machinery.

  • Respiratory Protection: When handling or spraying use an air-purifying respirator.
  • Skin protection: Use rubber gloves, remove immediately after contamination. Wear clean body-covering. Wash thoroughly with soap and water after work and before eating, drinking or smoking.
  • Eye / Face: Wear safety goggles to prevent splashing and exposure to particles in the air.
  • Waste generation should be avoided or minimized. Incinerate under controlled conditions in accordance with local laws and national regulations.

Consult the material and safety data sheet of the product (MSDS), or contact our technical department.