TECNOCOAT

Hot spray coatings
DESMOPOL

Liquid membranes
TECNOFLOOR

Flooring systems
TECNOFOAM H2O

Polyurethane spray foam water based
TECNOFOAM HFO

Polyurethane spray foams, HFO gas based
TECNOFOAM I

Injection polyurethane foams

PRIMER

Primer range
TECNOTOP

Aliphatic top coats
SUBSTRATE PREPARATION

Products for reinforcement, joints and singular points
ADDITIVES

FILLERS

DESMOSOLVENT

DESMOSOLVENT

Specific solvent for dilution and cleaning

Thinner and dluent for Desmopol polyurethane membrane and Tecnotop aliphatic resin topcoat. The dilution is only recommended by spray application ("airless equipment"). Also could be used for tools and equipment cleaning.



Uses

For application in the following situations:

  • recommended as a diluent for the polyurethane membrane Desmopol , and the Tecnotop  aliphatic resins for spray applications(by roll or brush is not necessary)
  • also recommended to use for cleaning equipment and tools.

NOTE: call our technical department about the application to other substrates or scopes of use

density 0.870 ±0.05 g/cm3
color transparent liquid absent of suspended matter


TDS. Technical Data sheet(PDF)
MSDS, CERTIFICATES, APPROVALS...(link)

PACKAGING

Metal tins of 25l.

SHELF LIFE

12 months at temperatures between 5 and 35° C (41 to 95 ºF), provided it is stored in a dry place.

HANDLING AND TRANSPORT

These safety recommendations for handling, are necessary for the implementation process as well as in the pre and post, on exposure to the loading machinery.

  • Respiratory Protection: When handling or spraying use an air-purifying respirator.
  • Skin protection: Use rubber gloves, remove immediately after contamination. Wear clean body-covering. Wash thoroughly with soap and water after work and before eating, drinking, or smoking.
  • Eye / Face: Wear safety goggles to prevent splashing and exposure to particles in the air.
  • Waste: Waste generation should be avoided or minimized. Incinerate under controlled conditions in accordance with local laws and national regulations.

Consult the material and safety data sheet (MSDS) of the product.

TECHNICAL DATA

PROPERTIES VALUES
color transparent liquid absent of suspended matter
moisture content 0.100%
density         ISO 1675 0.70 ±0.05 g/cm3
flashpoint 25°C (77ºF)
VOC (supplied) 860 - 880 g/l
recommended consumption ±5% on DESMOPOL and TECNOTOP

Results were performed in the laboratory at 20ºC and 50% RH, under controllable conditions. These values may vary depending on the application, climatology, or substrate conditions.